Lifan tires sizes

home ⇒ equipment ⇒ tires

Minimum tire size for the entire range of Lifan models is: 54.1 (mm).

Limit parameters for all models:
  • Tire sizes: from 54.1 to 67.1;
  • Disc sizes: from 24 to 45.
Tire marking:

In general, the standard European tire marking is a record in the form 175/65R15, where:

  • 175 is width of the work face of the tire;
  • 65 is percentage of profile height from tire width;
  • R15 is type of construction (R - radial) and inner diameter (in inches).

The American tire marking is similar to the European , but the size is preceded by P (for a motor (passenger) car) or LT (for a light truck).

If the height of rubber is 55% or less than its width, then the tire is considered low profile.

Important: the higher the proportionality of the tire (the ratio of the height of the profile to the width), the higher the tire, and vice versa: the lower the proportionality of the tire, the lower the tire.

Possible sizes for all Lifan models
General view spravka
General view

Tire spravka
Possible tire sizes for Lifan of different years of manufacture and modifications

Disk spravka
Possible disk sizes for Lifan of different years of manufacture and modifications

Wheel spravka
Possible wheel sizes for Lifan of different years of manufacture and modifications

Dimensions tires

(General view)		from 54.1 to 67.124
45
35
32
39
General tire parameters for all Lifan models
Size spravka
Tire size in format:

1. Width of work face.

2. Percentage of profile height from width.

3. R is type of construction (radial) - inner diameter (in inches).

spravka

B (mm) spravka
Tire width:

1. Nominal tire width (excluding protective belt).

2. Maximum width during operation.

spravka

D (mm) spravka
Tire diameter:

1. Nominal size of outer diameter (2xR) of the tire.

2. Maximum size during operation.

spravka

L (mm) spravka
Tire circumference in (mm)

H (mm) spravka
Tire profile:

Tire profile (height) for models of different years of manufacture.

spravka

n spravka
Wheel revolutions per (km) under standard conditions

Warning: the above data are official figures of the manufacturers, however, it should be borne in mind that the information is for reference and does not guarantee unambiguous accuracy.


0 Comments