# Disc sizes of FAW Besturn B50

The number of disk modifications for the Besturn B50 is: 0 (pcs).

### General parameters:

• Offset (ET): -;
• Drilling (PCD): -;
• Center hole (DIA): -.

Important: wheel disc parameter PCD indicates not only the diameter of circumference of the mounting holes, but also the number of mounting bolts or nuts (for example: 5x120, where 120 (mm) is the diameter of centers of the mounting holes, and 5 is the number of mounting bolts).

• .

### Procedure for calculating the disc offset:

The distance between mating face of the wheel (the face with which the disk is pressed against the hub) and the middle of the width of disk is called disk offset (ET).

The formula for calculating:

ET = A - B/2, where:

A is the distance between the inner plane of disk and the part in contact with the hub;

B is disk width.

The disk offset affects the width of the vehicle wheelbase, since the distance between the centers of symmetry (in width) of wheels on one axis directly depends on this parameter.

Important: PCD of disks with four fixing bolts (or nuts) corresponds to the distance between the centers of opposite bolts (or nuts), PCD of disks with five fixing bolts (or nuts) corresponds to the distance between the centers of any non-adjacent bolts (or nuts) multiplied by the coefficient 1.051.

General view wheel disks

Possible disk parameters for FAW Besturn B50
General view

(General view)
-
Table of disc sizes of FAW Besturn B50 modifications
FAW Besturn B50 1.6
2015xxx195/65R15x
2016xxx195/65R15x
2017xxx195/65R15x
2018xxx195/65R15x

Warning: despite the fact that the data are official figures of manufacturers, the above information is for reference only and does not guarantee unambiguous accuracy.