Disc sizes of Honda Freed

The number of disk modifications for the Freed is: (pcs).

General parameters:

Offset (ET): 50;
Drilling (PCD): 4x100;
Center hole (DIA): -.

Important: wheel disc parameter PCD indicates not only the diameter of circumference of the mounting holes, but also the number of mounting bolts or nuts (for example: 5x120, where 120 (mm) is the diameter of centers of the mounting holes, and 5 is the number of mounting bolts).

Possible disk sizes for Honda Freed:

14x5.5
15x5.5

Procedure for calculating the disc offset:

The distance between mating face of the wheel (the face with which the disk is pressed against the hub) and the middle of the width of disk is called disk offset (ET).

The formula for calculating:

ET = A - B/2, where:

A is the distance between the inner plane of disk and the part in contact with the hub;

B is disk width.

The disk offset affects the width of the vehicle wheelbase, since the distance between the centers of symmetry (in width) of wheels on one axis directly depends on this parameter.

Important: PCD of disks with four fixing bolts (or nuts) corresponds to the distance between the centers of opposite bolts (or nuts), PCD of disks with five fixing bolts (or nuts) corresponds to the distance between the centers of any non-adjacent bolts (or nuts) multiplied by the coefficient 1.051.

Wheel disks - full drawing

Possible disk parameters for Honda Freed

General view General view	Disk Possible disk sizes for Honda Freed of different years of manufacture and modifications	Wheel Possible wheel sizes for Honda Freed of different years of manufacture and modifications	ET (mm) Disk offset Distance between the vertical plane of symmetry of the wheel and the plane of contact of the disk to the hub. Measured in millimeters (mm)
(General view)	14'' 15''	14x5.5 15x5.5	50

Table of disc sizes of Honda Freed modifications

Year Model year of manufacture	Size Disk size in format: 1. D - diameter of the disk in inches. 2. x - a sign indicating the inseparability of the disk. 3. B - disk width in inches.	ET (mm) Disc offset: Distance between the vertical plane of symmetry of the wheel and the plane of contact of the disc to the hub.	PCD (mm) Disc drilling: 1. Number of bolt holes. 2. Diameter of the circle on which the mounting holes are located.	Tire Tire size in format: 1. Width of the work face. 2. Percentage of profile height to width. 3. R - type of construction (radial) - inner diameter (in inches).	DIA (mm) Center hole: Diameter of center hole, another marking is CH.
Honda Freed GB3
2008	14x5.5	50	4x100	185/70R14	x
2008	15x5.5	50	4x100	185/65R15	x

Warning: despite the fact that the data are official figures of manufacturers, the above information is for reference only and does not guarantee unambiguous accuracy.

Other parameters Honda Freed:

0 Comments