Disc sizes of JAC iEV7S
General parameters:
  • Offset (ET): -;
  • Drilling (PCD): -;
  • Center hole (DIA): -.

Important: wheel disc parameter PCD indicates not only the diameter of circumference of the mounting holes, but also the number of mounting bolts or nuts (for example: 5x120, where 120 (mm) is the diameter of centers of the mounting holes, and 5 is the number of mounting bolts).

Possible disk sizes for JAC iEV7S:
    Procedure for calculating the disc offset:

    The distance between mating face of the wheel (the face with which the disk is pressed against the hub) and the middle of the width of disk is called disk offset (ET).

    The formula for calculating:

    ET = A - B/2, where:

    A is the distance between the inner plane of disk and the part in contact with the hub;

    B is disk width.

    The disk offset affects the width of the vehicle wheelbase, since the distance between the centers of symmetry (in width) of wheels on one axis directly depends on this parameter.

    Important: PCD of disks with four fixing bolts (or nuts) corresponds to the distance between the centers of opposite bolts (or nuts), PCD of disks with five fixing bolts (or nuts) corresponds to the distance between the centers of any non-adjacent bolts (or nuts) multiplied by the coefficient 1.051.

    Wheel disks - full drawing
    Possible disk parameters for JAC iEV7S
    General view spravka
    General view

    Disk spravka
    Possible disk sizes for JAC iEV7S of different years of manufacture and modifications

    Wheel spravka
    Possible wheel sizes for JAC iEV7S of different years of manufacture and modifications

    ET (mm) spravka
    Disk offset

    Distance between the vertical plane of symmetry of the wheel and the plane of contact of the disk to the hub.

    Measured in millimeters (mm)

    Dimensions wheel disks

    (General view)
    16''
    -
    Table of disc sizes of JAC iEV7S modifications
    Year spravka
    Model year of manufacture

    Size spravka
    Disk size in format:

    1. D - diameter of the disk in inches.

    2. x - a sign indicating the inseparability of the disk.

    3. B - disk width in inches.

    spravka

    ET (mm) spravka
    Disc offset:

    Distance between the vertical plane of symmetry of the wheel and the plane of contact of the disc to the hub.

    spravka

    PCD (mm) spravka
    Disc drilling:

    1. Number of bolt holes.

    2. Diameter of the circle on which the mounting holes are located.

    spravka

    Tire spravka
    Tire size in format:

    1. Width of the work face.

    2. Percentage of profile height to width.

    3. R - type of construction (radial) - inner diameter (in inches).

    spravka

    DIA (mm) spravka
    Center hole:

    Diameter of center hole, another marking is CH.

    spravka

    EV
    2017xxx205/55R16x
    2018xxx205/55R16x

    0 Comments