Sizes of wheel болтов of Infiniti FX50

For the FX50 model, the wheel is attached to the hub using wheel болтов. The number of fasteners depends on the FX50 year of manufacture and is presented in the table below.

Total dimensions of fasteners:

  • Number of fasteners: 5 (units);
  • Fastener size: -;
  • Diameter of the mounting holes (PCD): 114.3 (mm);
  • Disc offset (ET): from 32 (mm) to 40 (mm).

Important: the above data are limits for all vehicle modifications, specific figures depend on the year of manufacture.

Rules for selecting wheel fasteners:

Different wheel fasteners are often used for cast and stamped disks - this applies to the length of the bolts, since the thickness of different types of disks can vary significantly.

When selecting any fasteners, special attention should be paid to the thread pitch. This parameter is always indicated after the “x” in the marking.

Most of the wheel fasteners have metric threads with fine pitch (М12х1.25/М12х1.5/М14х1.25/М14х1.5), which must correspond to the threads of thread studs or threaded holes in the wheel hub.

Important: the marking of fastener bolt M12x1.5 is deciphered as follows: thread with a nominal diameter of 12 (mm), thread pitch 1.5 (mm).



General parameters of wheel болтов of Infiniti FX50
General view spravkaGeneral view wheel fastener Quantity (units) spravka
Number of fasteners per hub for Infiniti model.

Dimensions (mm) spravka
Metric size of fasteners:

Thread M14 x 1.5 means:

M14 - thread diameter 14 (mm);
1.5 - thread pitch (distance between adjacent threads).

spravka
General view spravka
Type of wheel fastener:

For fastening of wheels or discs, 2 main types of fasteners are used:

-wheel bolts;
-wheel nuts.

Dimensions болтов
(чертеж болтов)
5 (units) - Болт
Size tables of wheel болтов of Infiniti FX50
Year Quantity (units) spravka
Number of fasteners per hub for Infiniti model.

Dimensions (mm) spravka
Metric size of fasteners:

ThreadM14 x 1.5 means:

M14 - thread diameter 14 (mm);
1.5 - thread pitch (distance between adjacent threads).

spravka
PCD (mm) spravka
Diameter between fasteners:

Diameter of the circle on which the mounting holes are located for Infiniti model.

spravka
ET (mm) spravka
Disc offset:

1. The distance between the vertical plane of symmetry of the wheel and the plane of contact of the disk to the hub.

spravka
Infiniti FX50 5.0L
20085x114.340
20095x114.340
Infiniti FX50 5.0 V8
20085x114.332
20085x114.340
20095x114.332
20105x114.332
20115x114.332
20125x114.332
20135x114.332

Warning: the above data are official figures of the manufacturers, however, it should be borne in mind that the information is for reference and does not guarantee unambiguous accuracy.