Wheel sizes of FAW Besturn B50

Minimum wheel diameter for the entire range of models is: 635-645 (mm).

General characteristics:

  • Wheel width in the standard state without load (B): 195-209 (mm);
  • Full diameter (D): 635-645 (mm);
  • Circumference (L): 1937 (mm);
  • Wheel profile, height (H): 127 (mm);
  • Rpm per 1000 (m): 501.7 (mm).

Possible wheel sizes for FAW model:

  • 195/65R15.

Fastener thread:

In most cases, wheel fastener thread has metric threads with fine pitch (М12х1.25/М12х1.5/М14х1.25/М14х1.5), which must correspond to the threads of thread studs or threaded holes in the wheel hub.

Important: fastening of wheel to the wheel hub is carried out using threaded connections, depending on the modification of vehicle, the designer uses bolts or studs with nuts.

Dimensions tires FAW Besturn B50 Dimensions wheel disks FAW Besturn B50

Possible sizes for all FAW models of different years of manufacture and modifications
General view spravkaGeneral view wheels Tires spravka
Maximum tire sizes for FAW

Wheel disks spravka
Possible disk sizes for FAW of different years of manufacture and modifications

Wheels spravka
Possible wheel sizes for FAW of different years of manufacture and modifications

Dimensions wheels FAW 195/65R15 min
(General view)
Table of dimensions of wheels of FAW Besturn B50
Year spravka
Year of production

Dimensions spravka
Tire size in format:

1. Width of work face.

2. Percentage of profile height from width.

3. R is type of construction (radial) - inner diameter (in inches).

B (mm) spravka
Wheel width:

1. Nominal wheel width (excluding protective belt).

2. Maximum width during operation.

D (mm) spravka
Wheel diameter:

1. Nominal size of outer diameter (2xR) of the wheel.

2. Maximum size during operation.

L (mm) spravka
Wheel circumference in (mm)

H (mm) spravka
Wheel profile:

Wheel profile (height) for models of different years of manufacture

Wheel revolutions per (km) under standard conditions

FAW Besturn B50 1.6

Warning: it should be borne in mind that the data given are the average characteristics of the product during operation. Depending on the load, atmospheric phenomena and the degree of pumping, the wheel parameters can vary. Limit values ​​are presented in the table above.